Resultats 1 - 12 sur un total de 17 réponses pour hk450gt

Yup, the HK uses 1.5mm for frame whereas the CX is Philips. Good hex is way better than Philips, no slipping.Did your SE V2 come with the cheap plastic blades? If so did you ever use it?

QUOTE=DemonHi Dale,I currently cant find any 450 size V2 blade grips on the site anywhere...  the Blue alloy "upgrade" ones are V1 (3mm FS) as are the plastic grips... if you have seen something im missing please link :DAs for the rotor hub, it seems you are correct, i was under the impression the hole through the hub was smaller so respect where its due.Take care all,Demon/QUOTE the last 2 sets of blue metal blade grips I ordered were V2 I doubt they will return to V1 :) If they had[...]

Any direct link to a suitable manual for the HK450GTPRO?

Does the new alloy HK450GT still suffer from failure of the tail rotor drive shaft/bearing. The original HK one on my plastic 450 failed after a dozen flights. (replaced with Align unit- no probs) What model of Trex 450 should be used for parts for the HK450GT?Thanks.C8

Hi friends:Which is the difference between the helicopter HK-450BB and the helicopter HK450GTPRO? Is it possible to exchange the parts between them?Thanks.

Hey, thanks for the reply.  I'll try harder to get the bolts out of the mixing arms.  So far I only tried a gas heat gun that I bought for heatshrink.  I might see if I can get better results with a soldering iron.  That's the number 1 issue I'm concerned about right now.But I should at least make it clear it's been flying, and I think pretty darn well, with the old arms.  I just had to limit the collective pitch range to -11 - +11, and the cyclic pitch movement is[...]

Hi ....need your help!!!I'm trying to setup the best throttle curve for my HK450GT, and ....i'm getting way too much headspeed ....for a regular curve(0-25-50-75-100). I'm using 0-22.5-32-45-60 as a throttle curve, and i'm hovering at around 37-45 ...at 5-6 degre of pitch, I use HeliTack(Iphone version), and i'm getting constant reading around 2700-2800 headspeed.Today, i try to setup the governor in my ESC ....to see if it will be a difference... again .....flat throttle curve at 30, governor[...]

I have just assembled an HK450GT and after my first flight I am really happy with it but I have noticed that the main Rotor Grips are a bit sl*ggy on the spindle shaftnot on the dampeners but on the bearing/thrust bearing part of the head.Any ideas......

Finally,after replacing the tail rotor shaft with the original align part(HS1203) I tried without adding the washers and everything looks spinning freely!I'm gonna leave it this way then.Hopefully nothing will go wrong!Pete.

Where can I get a complete head replacement for a HK450GT (grey colour). I can't seem to find it in the parts section.

Really sorry I should have been more specific lol, it's to go on a HK450GT Pro, thinking HTX900's for cyclic as people seem to say there adequate?....   Any help greatly received.   John

Hi,I bought the kit HK450 (PRODUCT ID: HK-450BB) and now I find many variations: HK450MT, HK450GT, HK450TT, HK450Pro and HK450V2.Spares are exhausted for the version  HK450BB. But they have spare parts in stock in the other versions.How I can be certain about the compatibility of the parts?¿I can buy parts for my HK450BB of other versions?I've found some compatible spares, but I need to understand what is the difference.Thanks,